MIROLAC NC 3125 Universal White Undercoat

• Very fast drying speeds up production throughput
• Easy to sand, powders easily reducing sanding time.
• Minimises the risk of wax extraction over MDF and HDF.
• Single pack, no pot life issues to manage
• Formaldehyde free, safer for the applicator, zero formaldehyde emissions in rooms in which articles are installed.
• Phthalate free it is ideal for use on children’s toys and furniture.
   

Colour : White
Build : Very Good
Sandability : Very Good
Vertical Hold Up : Very Good
Solvent Resistance : Resists splash and spillage of mineral turps but has poor resistance to industrial solvents
Water Resistance : Fair
Levelling & Flow : Excellent
Sink Back : Minimal
Coverage : 6m2 per litre at 150 micron wet film build. This is dependent on the application equipment / gun set up and the article being coated
Dry Time : Refer to Technical Data Sheet
Clean Up : Clean all equipment using MIROSOL 1222 or 1286 Thinner
 

Data Sheet

Safety Data Sheets

Mirotone Warranty Information

Thinning : Thin 25-40% with MIROSOL 1222 or 1220 (Fast), 1294 (Medium), 1242 (Slow)
 

Suction Gun - Use 1.5 to 2mm (59-79 thou) orifice with 350-400kpa (50-55 psi).
Pressure Pot - Use 1.5 to 2mm (59-79 thou) orifice with pressure pot air-cap. Gun pressure 350-400kpa (50-55 psi) and a pot pressure of 45kpa (6 psi) max.
Airless Spray - Use 0.23 to 0.33mm (9-13 thou) orifice, 15cm fan (dependent on job) with regulated pump pressure of 350-400kpa (50-55 psi).
Air Mix Guns - Settings similar to airless spray with the air-assisted regulator pressure at 70-90kpa (10-15psi).
Curtain Coating - 40-60 seconds viscosity with applied wet film thickness of 150 microns.

Interior use only. Ideal for domestic furniture, internal doors, children’s toys and furniture, picture frames, musical instruments, MDF building products and peg boards for display areas. When top coated with MIROBILD AC topcoats or MIROTHANE PU topcoats this product may be used on kitchen cabinets and commercial furniture.