MIROTHANE PU 5640 2K Metallic / Pearlecent Tint Base

Code: 5640

A fast drying, two pack polyurethane metallic / pearlescent tint base.

Features

Features

  • Fast drying
  • Easy to apply
  • Excellent adhesion to MDF, LPM and glass (when cleaned with MIROLOK 3508 Glass Clean & Prime)
  • Metallic available in medium (3940) or Coarse (3944)
  • Pearlescent available in Fine (3950) or Coarse (3957)

Specifications

Specifications

Colour : Standard colour range
Build : Low
Vertical Hold Up : Very Good
Solvent Resistance : Very Good
Water Resistance : Excellent
Levelling & Flow : Excellent
Sink Back : Minimal
Coverage : 13m2 per litre at 75 micron wet film build. This is dependent on the application equipment / gun set up and the article being coated
Dry Time : Refer to Technical Data Sheet
Clean Up : Clean all equipment using MIROSOL 1222 or 1286 Thinner

 

Tech Data Sheet

Tech Data Sheet

Application

Application

Mixing Ratio (by volume) : 10 Parts 5640 Part A + 1 Part 5789 (10A:1B)
Pot Life : 4 hours at 25°C Pot life varies significantly with ambient temperature, humdity and the quantity mixed. Pot life is longer at lower temperatures and shorter at higher temperatures. The larger the quantity mixed, the shorter the pot life will be. Only mix the quantity required for the job.
Thinning : Thin 50-70% with MIROSOL 1232, 1224, 1217 (Fast)

 

Suction Gun - Use 1.5 to 2mm (59-79 thou) orifice with 350-400kpa (50-55 psi).
Pressure Pot - Use 1.5 to 2mm (59-79 thou) orifice with pressure pot air-cap. Gun pressure 350-400kpa (50-55 psi) and a pot pressure of 45kpa (6 psi) max.
Airless Spray - Use 0.23 to 0.33mm (9-13 thou) orifice, 15cm fan (dependent on job) with regulated pump pressure of 350-400kpa (50-55 psi).
Air Mix Guns - Settings similar to airless spray with the air-assisted regulator pressure at 70-90kpa (10-15psi).

Where to Use

Where to Use

Kitchen and bathroom cabinets, wall panelling, commercial furniture and fit-outs, glass splashbacks, glass furniture, metal furniture and automotive.

To top