MIROTHANE PU 5588 Clear Topcoat

• Can be applied over a range of sealers including MIROCAT PC 3241 and MIROCAT PC 3242 Preact Sealers and MIROTHANE PU 5533 and MIROTHANE PU 5545 Polyurethane
• Excellent flow and levelling
• Economical – a cost effective furniture grade polyurethane topcoat

Colour : Clear
Finish : Satin (30%) and Satin (20%)
Build : Very Good
Sandability : Very Good
Vertical Hold Up : Good
Solvent Resistance : Very Good
Water Resistance : Very Good
Levelling & Flow : Excellent
Sink Back : Minimal
Coverage : 6-7m2 per litre at 150 micron wet film build. This is dependent on the application equipment / gun set up and the article being coated
Dry Time : Refer to Technical Data Sheet
Clean Up : Clean all equipment using MIROSOL 1222 or 1286 Thinner

Data Sheet

Safety Data Sheets

Mirotone Warranty Information

Mixing Ratio (by volume) : 4 Parts 5588 Part A + 1 Part 5747 Part B (4A:1B) or 10 Parts 5588 Part A + 1 Part 5715, 5728, 5735 or 5757 (10A:1B)
Pot Life : 4-6 hours at 25°C Pot life varies significantly with ambient temperature, humdity and the quantity mixed. Pot life is longer at lower temperatures and shorter at higher temperatures. The larger the quantity mixed, the shorter the pot life will be. Only mix the quantity required for the job.
Thinning : Thin 20-40% with MIROSOL 1217 (Fast), 1263 (Medium), 1266 (Slow)
 

Suction Gun - Use 1.5 to 2mm (59-79 thou) orifice with 350-400kpa (50-55 psi).
Pressure Pot - Use 1.5 to 2mm (59-79 thou) orifice with pressure pot air-cap. Gun pressure 350-400kpa (50-55 psi) and a pot pressure of 45kpa (6 psi) max.
Use 0.23 to 0.33mm (9-13 thou) orifice, 15cm fan (dependent on job) with regulated pump pressure of 350-400kpa (50-55 psi).
Air Mix Guns - Settings similar to airless spray with the air-assisted regulator pressure at 70-90kpa (10-15psi).

Interior use only. Domestic furniture, commercial joinery and kitchen cabinets