MIROTHANE PU 5500 Isolator

• Fast drying
• No sanding required
• Water white, excellent clarity
• Excellent adhesion to wood, MDF & LPM

Colour : Clear
Build : Low
Vertical Hold Up : Good
Solvent Resistance : Good
Water Resistance : Excellent
Levelling & Flow : Excellent
Sink Back : Minimal
Coverage : 10m2 per litre at 100 micron wet film build. This is dependent on the application equipment / gun set up and the article being coated
Dry Time : Refer to Technical Data Sheet
Clean Up : Clean all equipment using MIROSOL 1222 or 1286 Thinner
 

Data Sheet

Safety Data Sheets

Mirotone Warranty Information

Mixing Ratio (by volume) : When used as a two pack mix 10 Parts 5500 Part A + 1 Part 5789 (10A:1B).
Pot Life : 4 hours at 25°C Pot life varies significantly with ambient temperature, humidity and the quantity mixed. Pot life is longer at lower temperatures and shorter at higher temperatures. The larger the quantity mixed, the shorter the pot life will be. Only mix the quantity required for the job.
Thinning : Thin single pack 20-30% and two pack 12-25% with MIROSOL 1217 (Fast), 1263 (Medium), 1266 (Slow).
 

Suction Gun - Use 1.5 to 2mm (59-79 thou) orifice with 350-400kpa (50-55 psi).
Pressure Pot - Use 1.5 to 2mm (59-79 thou) orifice with pressure pot air-cap. Gun pressure 350-400kpa (50-55 psi) and a pot pressure of 45kpa (6 psi) max.
Airless Spray - Use 0.23 to 0.33mm (9-13 thou) orifice, 15cm fan (dependent on job) with regulated pump pressure of 350-400kpa (50-55 psi).
Air Mix Guns - Settings similar to airless spray with the air-assisted regulator pressure at 70-90kpa (10-15psi).

Tannin blocking primer under MIROTEC WB water based coatings, mouldings, picture frames, MDF furniture and fixtures, MDF routed grooves and solid Jarrah furniture and articles.