MIROPOL PE 5111 White Undercoat

Code: 5111

MIROPOL PE 5111 is a premium, high build, white polyester undercoat for MDF and particleboard. When top coated with one of Mirotone’s full gloss polyurethane topcoats, it provides the ideal base to achieve the “wet look” European finish.

Features

Features

  • Excellent build and excellent flow and levelling results in high distinction of image (DOI) when top coated with a full gloss polyurethane topcoat
  • Superior vertical hold up makes it easy to apply high film weights without sags and runs
  • Excellent opacity, especially over sharp edges
  • Slight sheen allows operators to easily see where they have sanded
  • May be ordered as a two-pack with the cobalt pre added

Specifications

Specifications

Colour : White
Specific Gravity : 1.43
Build : Excellent
Sandability : Excellent
Vertical Hold Up : Excellent
Solvent Resistance : Very Good
Water Resistance : Very Good
Levelling & Flow : Excellent
Sink Back : Minimal
Coverage : 3m2 per litre at 300 micron wet film build. This is dependent on the application equipment / gun set up and the article being coated
Dry Time : Refer to Technical Data Sheet
Clean Up : Clean all equipment using MIROSOL 1208 or 1234 Thinner

 

Tech Data Sheet

Application

Application

Mixing Ratio : Mix by volume, 1 Litre 5111 Part A + 20ml 5202 Accelerator + 10ml peroxide (MEKP) Catalyst (100:2:1) Always mix 5202 Accelerator into the 5111 Part A base before adding the peroxide (MEKP Catalyst). Mixing the Accelerator and the Peroxide Hardener together may cause an explosion or fire.
Pot Life : Approximately 45 minutes at 25°C. Pot life varies significantly with ambient temperature and the quantity mixed. Pot life is longer at lower temperatures and shorter at higher temperatures. The larger the quantity mixed, the shorter the pot life will be. Only mix the quantity required for the job. Refer to the MIROPOL PE Polyester Product Information Guide for mixing ratios to extend pot life.
Thinning : 30-40% with MIROSOL 1208 (Fast), 1234 (Medium) or 1224 (Slow) Thinner.

 

Suction Gun - Use 1.5 to 2mm (59-79 thou) orifice with 350-400kpa (50-55 psi).
Pressure Pot - Use 1.5 to 2mm (59-79 thou) orifice with pressure pot air-cap. Gun pressure 350-400kpa (50-55 psi) and a pot pressure of 45kpa (6 psi) max.
Airless Spray - Use 0.23 to 0.33mm (9-13 thou) orifice, 15cm fan (dependent on job) with regulated pump pressure of 350-400kpa (50-55 psi).
Air Mix Guns - Settings similar to airless spray with the air-assisted regulator pressure at 70-90kpa (10-15psi).

Where to Use

Where to Use

Interior use only. Interior doors, kitchen & bathroom cabinets, commercial joinery and wall panelling and domestic furniture.

To top