MIROKEY VY 6640 Black Etch Primer

Code: 6640

Polyvinyl butyryl epoxy primer suitable for application on aluminium, mild steel, galvanised iron, copper and brass. It is a single product self-etching satin coating.

Features

Features

  • Single Pack, easy to use
  • Excellent adhesion on cleaned surfaces
  • Fast drying

Specifications

Specifications

Colour : Black
Solvent Resistance : Fair
Water Resistance : Fair
Levelling & Flow : Good
Sink Back : Minimal
Coverage : 7-10m2 per litre at 150 micron wet film build. This is dependent on the application equipment / gun set up and the article being coated
Dry Time : Refer to Technical Data Sheet
Clean Up : Clean all equipment using MIROSOL 1286 Thinner
 

Tech Data Sheet

Tech Data Sheet

Data Sheet

Safety Data Sheets

Mirotone Warranty Information

Application

Application

Thinning : Thin 5 to 15% with MIROSOL 1234 or 1286 Fast or 1294 Medium Thinner.
 

Suction Gun - Use 1.5 to 2mm (59-79 thou) orifice with 350-400kpa (50-55 psi).
Pressure Pot - Use 1.5 to 2mm (59-79 thou) orifice with pressure pot air-cap. Gun pressure 350-400kpa (50-55 psi) and a pot pressure of 45kpa (6 psi) max.
Airless Spray - Use 0.23 to 0.33mm (9-13 thou) orifice, 15cm fan (dependent on job) with regulated pump pressure of 350-400kpa (50-55 psi).
Air Mix Guns - Settings similar to airless spray with the air-assisted regulator pressure at 70-90kpa (10-15psi).

Where to Use

Where to Use

General metal furnishings, office furniture, filing cabinets, hand rails, gates, trusses, bull bars, two bars, earth moving and materials handling, shot blast holding primer, plant & machinery equipment and tanks.
 

To top