MIROKEY VY 6615 Etch Primer

Code: 6615

High performance, zinc phosphate etch primer specifically designed for direct application over mild steel, zinc-anneal, chrome, brass, lead and lead alloys, stainless steel, aluminium and galvanised iron.

Features

Features

  • Excellent adhesion to a variety of cleaned metal surfaces
  • Single pack, easy to use
  • Contains zinc phosphate, proven corrosion resistance
  • Fast drying

Specifications

Specifications

Colour : White or Grey
Build : Good
Vertical Hold Up : Excellent
Solvent Resistance : Dependent on topcoat
Water Resistance : Very Good
Levelling & Flow : Very Good
Sink Back : Minimal
Coverage : 7-10m2 per litre at 150 micron wet film build. This is dependent on the application equipment / gun set up and the article being coated
Dry Time : Refer to Technical Data Sheet
Clean Up : Clean all equipment using MIROSOL 1234 or 1286 Thinner
 

Tech Data Sheet

Tech Data Sheet

Data Sheet

Safety Data Sheets

Mirotone Warranty Information

Application

Application

Thinning : Thin 5 to 15% with MIROSOL 1234 or 1286 Fast or 1294 Medium Thinner.
 

Suction Gun - Use 1.5 to 2mm (59-79 thou) orifice with 350-400kpa (50-55 psi).
Pressure Pot - Use 1.5 to 2mm (59-79 thou) orifice with pressure pot air-cap. Gun pressure 350-400kpa (50-55 psi) and a pot pressure of 45kpa (6 psi) max.
Airless Spray - Use 0.23 to 0.33mm (9-13 thou) orifice, 15cm fan (dependent on job) with regulated pump pressure of 350-400kpa (50-55 psi).
Air Mix Guns - Settings similar to airless spray with the air-assisted regulator pressure at 70-90kpa (10-15psi).

Where to Use

Where to Use

Metal fabrication, box trailers, caravans, safes, plant & machinery, farming equipment, earth moving equipment, skip bins and automotive.
 

To top