MIROCAT PC 3244 Clear Sealer

Code: 3244

High build, single pack, clear pre-catalysed sanding sealer that provides an excellent base for a range of Mirotone topcoats.

Features

Features

  • High build provides improved hold up and reduces the number of coats required
  • Easy to use, achieve an excellent finish with minimal effort
  • May be catalysed with MIROBILD AC 3800 Universal catalyst to improve chemical resistance when using as a sealer under acid catalysed and polyurethane topcoats
  • Fast drying allows early sanding which minimises production time

Specifications

Specifications

Colour : Milky in can, dries clear
Build : High
Sandability : Excellent
Vertical Hold Up : Very Good
Solvent Resistance : Good
Water Resistance : Good
Levelling & Flow : Excellent
Sink Back : Minimal
Coverage : 6m2 per litre at 150 micron wet film build. This is dependent on the application equipment / gun set up and the article being coated
Dry Time : Refer to Technical Data Sheet
Clean Up : Clean all equipment using MIROSOL 1222 or 1286 Thinner

 

Tech Data Sheet

Application

Application

Mixing Ratio (by volume) : To improve the water and chemical resistance of the coating system, add 20ml of MIROBILD AC 3800 Catalyst to every litre of MIROCAT PC 3244 and then add thinner. Apply catalysed coating within two days of adding catalyst.
Pot Life : 2 days at 25°C Pot life varies significantly with ambient temperature, humidity and the quantity mixed. Pot life is longer at lower temperatures and shorter at higher temperatures. The larger the quantity mixed, the shorter the pot life will be. Only mix the quantity required for the job.
Thinning : Thin 15-30% with MIROSOL 1222 or 1220 (Fast), 1294 (Medium), 1242 (Slow)
 

Suction Gun - Use 1.5 to 2mm (59-79 thou) orifice with 350-400kpa (50-55 psi).
Pressure Pot - Use 1.5 to 2mm (59-79 thou) orifice with pressure pot air-cap. Gun pressure 350-400kpa (50-55 psi) and a pot pressure of 45kpa (6 psi) max.
Airless Spray - Use 0.23 to 0.33mm (9-13 thou) orifice, 15cm fan (dependent on job) with regulated pump pressure of 350-400kpa (50-55 psi).
Air Mix Guns - Settings similar to airless spray with the air-assisted regulator pressure at 70-90kpa (10-15psi).

Where to Use

Where to Use

Interior use only. Ideal for domestic furniture, children’s toys and furniture, picture frames, musical instruments, joinery and antique restoration. When catalysed and top coated with MIROBILD AC topcoats or MIROTHANE PU 5588 Clear Topcoat may be used on kitchen cabinets and commercial furniture.

To top